Immediately clean grey or black soiled grout, tiles, and ceilings with Kruidvat Bright Mold Remover. Use Kruidvat Bright Mold Remover safely. Read the label and product information before use.
How to use Kruidvat Bright Mold Remover?
For disinfecting (tiled) walls, grout, and ceilings in bathrooms, showers, toilets, kitchens, basements, cellars, saunas, swimming pools, garages, and sheds. The product bleaches grey and black moldy areas. Test a small, inconspicuous area for colorfastness and durability beforehand. Always wear gloves and protective clothing due to the bleaching effect; be careful of splashes on non-chlorine-resistant surfaces and wipe off immediately with water. Ensure adequate ventilation. Do not inhale spray mist. Do not remove mold before application.
Set the spray nozzle to the spray position, spray the surface from a distance of approximately 3-5 centimeters, and let it act for 10 minutes. In case of heavy soiling, repeat the treatment after 10 minutes. Preferably treat elastic joints (e.g. silicone sealant) twice. With light elastic joints, some brown discoloration may occasionally remain after use. After use, return the spray nozzle to the non-spray position. Thoroughly clean the sprayed surface with a sponge and water afterwards.
Do not use on:
Textiles and floor coverings (bleach stains), (bare) metals, glossy paintwork (matting), tiles with a fragile or damaged glaze layer (discoloration possible). If necessary, cover these surfaces for safety during use. In case of contact with these surfaces, rinse immediately with water. Do not use in combination with acids and other products.
Consumption:
Sufficient for 4-6 m² of wall, 12-16 m² of tile grout or 2-3 m² of ceiling (depending on the degree of contamination).
Active ingredients:
Sodium hypochlorite (CAS 7681-52-9): 4.85%
Legal instructions for use:
Use is permitted exclusively as a means of combating mold (black deposits) in damp places. The dosage and contact time as indicated in the instructions for use must be observed. The product is intended for non-professional use.
Warning:
Forms toxic gas in contact with acids. May be corrosive to metals. Causes skin irritation. Causes serious eye irritation. Very toxic to aquatic organisms, with long-lasting effects. Keep out of reach of children. When seeking medical advice, keep the packaging or label available. Do not inhale spray mist. Clean up spilled or leaked material. Dispose of contents/packaging to a hazardous waste collection point, in accordance with legal regulations and provisions. Caution! Do not use in combination with other products. Dangerous gases (chlorine) may be released. Contains: Sodium hypochlorite solution 53.7 g/l.
Authorization number:
11514B
EAN code:8717333538989,8717333989903
Functional Name
Mold remover
GHS signal word
Warning
UN code
1170
P-phrases
P101: If medical advice is needed, have the packaging or label available P102: Keep out of reach of children P260: Do not inhale dust/fumes/gas/mist/vapour/spray P273: Avoid release to the environment P391: Clean up spilled/leaked material P501: Dispose of contents/packaging to ...
H-phrases
EUH031: Forms toxic gas in contact with acids.EUH206: Caution! Do not use in combination with other products. Dangerous gases (chlorine) may be released.H290: May be corrosive to metals.H315: Causes skin irritation.H319: Causes serious eye irritation.H400: Very toxic to aquatic organisms.H410: Very toxic to aquatic organisms, with long-lasting effects.
Contents (Net)
500 mg
Comment